i²c Multiplexer

Daniel Sendula — Mon, 10 Dec 2018 21:43:00 GMT

i²c Multiplexer

For steering wheels we need 4 x AS5600 and, unfortunately, AS5600 only has one i²c address and it cannot be moved. So the only way to overcome this problem is to introduce an i²c multiplexer - a chip to allow splitting of i²c bus to many sub-buses. For this we chose PCA9545A, a 4 way multiplexer. But they don't make it in DIP packages as well and 24 pin adapter was in order, too.

But, 4 way multiplexer has quite a few wires, especially if we want to use each sub-bus several times. For instance, on each sub-bust we can put two VL53L1X with only one extra GPIO (to discriminate between two VL53L1X sensors in setup). That would mean that from this tiny chip we would need to draw 5 (GND, VCC, SDA, SCL, GPIO) x 3 (2 x VL53L1X and AS5600) x 4 (4 sub-buses) + another 5 (GND, VCC, SDA, SCL, GPIO - connection to main bus) lines. 64 in total! OK, we can omit 4 x GPIO to AS5600 but that's pretty much it. Here's what we did to alleviate situation:

Games Creators Club PiWars Blog (Posts about i2c)

i²c Multiplexer

i²c Multiplexer